Bison Montage Kit bige 350g

· Suitable for joining non-porous materials together
· Permanently elastic
· Universally applicable
· Suitable for uneven surfaces
· Shortly correctable
· Water resistant
· Temperature resistant
PREPARATION
Working Conditions: Only apply at temperatures between +5 °C
and +40 °C.
Surface Requirements: Both parts must be dry, clean and free of
dust and grease.
Tools: Use putty knife or spatula to apply. If necessary, use a
rubber mallet to tap lightly.
APPLICATION
Coverage: Wall covering sheets and panels: about 5-8 m²/
kg depending on the weight of the material. Lathing, skirting
boards and timber framework: about 4-6 m²/kg glued surface.
Directions for use:
Before using open cartridge at the top by cutting off the plastic
nipple above the thread with a sharp knife. Fix the nozzle onto
the cartridge and cut at an angle to the desired diameter.
Cut off screw thread, assemble nozzle and cut to a diameter of
at least 0.5 cm.
Depending on the weight of the material, apply the adhesive
evenly in vertical strips or dots at intervals of between 20 and
40 cm. Always apply adhesive to the corners and along the
edges. Assemble materials with a pushing movement and press
or knock firmly together. Correction is still possible. With heavy
materials, materials under stress, or two non-porous materials,
apply the power bonding method. Mount material, press and
immediately loosen. Let dry for 5 minutes, assemble in the same
place and press firmly or hammer. Adjustment is not possible.
For heavy materials, fastenings or supports may be required.
Stains/residue: Use white spirit for cleaning tools and removing
wet adhesive residue. Dry adhesive residue can only be
removed mechanically.