Bison Kit Contact adhesive 3L

PREPARATION
Working Conditions: Use adhesive and parts to be bonded at
room temperature only. The relative humidity must be below
65%. This is to avoid formation of bubbles in the final product.
Once attached, adjustment is no longer possible. Always test on
an (inconspicuous) part of the surface first.
Surface Requirements: Surfaces must be dry, clean, dust- and
grease-free and a good fit.
Preliminary Surface Treatment: Clean and degrease the surfaces to
be bonded for optimal results.
Tools: Use a solid brush or fine-toothed (1 mm) glue spreader
to cover large surfaces. Use a roller or rubber mallet to join the
materials firmly.
APPLICATION
Coverage: 2-2.5 m²/litre, applied on both sides, depending on
the nature of the materials to be bonded.
Directions for use:
Should preferably not be diluted.
Parts must be clean, dry and free of grease. Coat both
substrates completely. Allow to dry for a minimum of 10-40
minutes. In case of porous materials, apply a second coat and
let dry. Then join parts and roll or tap firmly (with a rubber
mallet).
Stains/residue: Remove wet adhesive residue immediately. Dried
excess adhesive can only be removed mechanically or with a
paint stripper (pre-test).
Points of attention: For optimum results, both the adhesive and
the parts to be bonded must be at room temperature (definitely
do not use below +10°C). The final bonding strength depends
on the pressure applied. Therefore, press as firmly as possible
across the entire surface. Should the adhesive joint between
porous materials be exposed to long-lasting contact with water,
the adhesive may detach from the wet surface.